Purification Workbench Maintenance: How to maintain a clean working environment
So how do you maintain and clean the workbench? Check and unplug the power cord during maintenance. In order to maintain the technical performance of the workbench, the initial setting, daily operation and maintenance of the equipment are crucial. If you despise these matters, the performance of the equipment will cause the workbench to run in an incomplete state. 1. Sealability This workbench uses a structure in which all positive pressure contaminated areas are surrounded by negative pressure zones. 2. Moreover, before the sterilization of the workbench with formaldehyde fumigation, in order to prevent formaldehyde leakage, the whole machine should be checked for tightness by the “soap bubble†method. 3. Regularly (usually every two months) measure the wind speed of the working area with an anemometer. If the requirements of the technical parameters are not met, the fan supply voltage can be adjusted. 4. When the fan voltage is adjusted to the maximum, if the wind speed in the work area still does not meet the requirements of the technical parameters, the air supply high efficiency filter must be replaced. When the air supply high efficiency filter is replaced, the exhaust air high efficiency filter must also be replaced. After the replacement, apply the dust particle counter to check whether the four perimeter seals are good. If there is any leak, seal it with sealant. 5. The fan does not require special maintenance, but a regular inspection is recommended. Makeup Brush Travel Set,Custom Makeup Brushes,Oval Makeup Brush Set,7Pcs Brush Set DONGGUAN YACAI COSMETICS CO.,LTD. , https://www.yacaicosmetic.com