Operators must read - water in the water park swimming pool turns green, how to deal with is the right approach?
I believe everyone should have watched the water in the swimming pool when playing in the swimming pool or the general water park. I remember that the general swimming pool is covered with blue tiles. The water in the pool looks like blue tiles. It is blue, and chlorine is added to the water. I do not know if we still remember the Rio Olympic Games in 2016. I believe many swimmers should remember that the Olympic swimming pool water turned green last year. What causes the pool water to turn green? In general, swimming pools with normal water quality should have a residual chlorine content of 0.3-0.5 mg/L and a pH of 7.4-7.6. In this environment, bacteria and algae are not likely to grow and multiply. After continuous rain, the residual chlorine in the water will not reach the standard, and the pH of the water will decrease, so that bacteria and algae have room for growth. And when it rains, spores in the air, grass and soil erosion products will enter the algae into the water, then in the summer swimming pool water temperature is high (usually 28-30 degrees), bacteria and algae will rapidly multiply, so that The water in the pool turned green in a short time. To solve this problem, follow these steps: 1. The first step is to add copper sulphate, which is usually 1-2 times more than usual. This is because there are few algae in the water, and algae are abundant after the water is green. Therefore, it is necessary to add enough algaecide (sulfuric acid). Copper can fully kill algae. After adding the algicide (copper sulphate), the circulatory system should be opened so that the pharmacy is as uniform as possible in the water, thus giving the best results; 2. After about 2 hours, add the trichloroisocyanuric acid disinfectant at the standard dosage of 4 kg per 1000 cubic meters of water (normally, add 2 kg per 1,000 cubic meters of water). This is what we usually call impact. Treatment or ultra-chlorine treatment to fully sterilize and disinfect swimming pool water; 3. After about 2 hours, the PH value of the water is measured. Generally, after the rain has passed and the trichloroisocyanuric acid disinfectant is used, the pH of the water will certainly be low. Therefore, only use a pH-increasing regulator (flakes). ) The PH value of the water can be increased. The amount of water added is calculated by adding 1 kg per 1000 cubic meters of water and increasing the amount by 1 degree. It is best to adjust the pH to 7.5; 4. Add precipitant at night, and add 5-8kg per 1,000 cubic meters of water as standard, so that fine algae and other suspended solids that have been killed in water can be precipitated to the bottom of the pool; 5, the next day with a suction machine to remove sediment from the bottom of the pool. Through the above 5 steps, the water in the swimming pool can be cleared This article is edited by the company's Amusement Xiaobian. For more information about children's play equipment, children's home manufacturers, slide manufacturers, etc., please visit our official website: http:// or call our hotline. Led Hexagonal Light,Hexagon Wall Lights,Hexagon Rgb Lights,Drawing Pad,Digital Drawing Pad Guangdong Jishengke Industrial Co.,Ltd , https://www.jskpad.com
