Use the vacuum cleaner when cleaning the snowflake ice machine
The ice making principle of the ice machine: 1. The chilled water of the water storage tank is continuously circulated through the plate or the compartmentalized evaporator; 2. After the compressor is operated, the air is sucked-compressed-exhausted-condensed (liquefied ) - throttling - vaporization at a low temperature of -10 ° C to -18 ° C in the evaporator. The chilled water continuously condenses into an ice layer on the surface of the lower temperature evaporator at a water temperature of 0 °C. When the ice layer condenses to a certain thickness, the evaporation temperature of the refrigerant reaches the temperature set temperature, that is, the defrosting solenoid valve is turned on, and the heat pump is used to de-ice, and the next cycle is realized. Ice machine use tips 1, ice machine should be installed away from heat, no direct sunlight, good ventilation, the ambient temperature should not exceed 35 ° C, to prevent the ambient temperature is too high, resulting in poor condenser heat dissipation, affecting the system Ice effect. The floor on which the ice machine is installed should be solid and flat, and the ice machine must be level, otherwise it will cause no ice and noise during operation. 2. The gap between the back and left and right sides of the ice making machine should be no less than 30cm, and the top clearance should be no less than 60cm. 3, the ice machine should use independent power supply, dedicated line power supply and equipped with fuses and leakage protection switches, and must be reliably grounded. 4. The water of the ice machine should conform to the national drinking water standard, and a water filtration device should be installed to filter the impurities in the water to avoid blocking the water pipe and polluting the water tank and the ice mold. And affect the performance of ice making. 5. When cleaning the ice machine, the power should be turned off. It is strictly forbidden to use the water pipe to directly align with the body. Use a neutral detergent to scrub. Do not use acidic or alkaline solvents to clean. 6. The ice machine must unscrew the inlet hose head for two months to clean the inlet valve screen to prevent the sand mud impurities from clogging the water inlet, which causes the water intake to become smaller, resulting in no ice. 7. The ice machine must clean the surface of the condenser every two months. If the condensation is poor, the compressor components will be damaged. When cleaning, use a vacuum cleaner, a small brush, etc. to clean the condensed surface oil dust. Do not use a sharp metal tool to clean it to avoid damaging the condenser. 8. The water pipes, sinks, storage refrigerators and protective film of the ice machine should be cleaned every two months. Shanghai Xinzhuang Instrument Co., Ltd. is a technologically innovative high-tech enterprise based in Shanghai and radiating the whole country. The company has first-class technicians and a good team of technicians, with advanced technology and strong development strength. Http:// Product categories of Melamine Dinnerware, we are specialized sellers for Melamine Dishes, Melamine Dinner Plates, Melamine Dinnerware Sets, sells high-quality products of Melamine Tableware. ARC USA, focuses on kitchen supplies, gives you the best product experience, the best product service. Don't wait! Just buy it now! Melamine Dinnerware Melamine Dishes,Melamine Dinnerware Sets,Melamine Dinner Plates,Melamine Tableware ARC Advanced Royal Champion , https://www.arcimportcorp.com