Box Design Case Analysis (6)
Mould Stries,Silicon Baking Mould,Silicone Bakeware Mold,Bakeware Mold Changshu Xinneng Silicone Products Co., Ltd. , https://www.xnsilicone.com
20, then select a flip B (two previously copied) and select the rectangle where the trademark A is located, press the "B" key to align the bottom of the rectangle, as shown in Figure 20, then hold down the Ctrl key Flip the mouse down and a box is basically completed, as shown in Figure 21:
21. Select the rectangle tool and draw a rectangle on the right side of pattern A. The size is 15 x 64mm. Select the rectangle and select pattern A. Press the “E†or “R†key to align; then press and hold the Ctrl key. Drag the mouse from left to right out of the frame of pattern A, as shown in Figure 22:
(to be continued)