How to add ink to hp ink cartridge
HP recognizes that "the ink cartridge is not installed correctly", ignore it, and click OK to remove the ink cartridge, the method is the same as above; After the ink is added, it is necessary to clean it. Is it a miracle? HP has recognized that it has just installed a new ink cartridge, and finally added yellow. HP recognizes again that "the ink cartridge is not installed correctly". Remove the ink cartridge, especially the earthworm-shaped ventilation groove must be wiped clean to avoid blocking the ventilation groove to affect the inkjet effect or even no ink. Stick the ink tape of the ink cartridge as it is. I personally do not recommend ink flushing. The continuous supply is much better than this. The ink may be injected too much by accident. After the ink is added, the ink cartridge counter must be cracked and cleared, otherwise HP still recognizes that the ink cartridge is empty (although it is full of ink). To clear the ink cartridge counter, cover the top of the second line on the left with adhesive tape, and then install it on the printer. These man-made machine failures are no longer covered by the warranty And you can't guarantee the quality of the ink you buy must be good Highly likely to damage the nozzle (blocked) Attach a simple method, the ink injection port is under the ink = box that cannot be opened. Carefully tear off the back and use the preparation work: prepare the ink to be added Tools: small scissors, transparent plastic paper, â‘¡ remove two small pieces of transparent plastic paper, clean the ink cartridge chip touch, and install it on the printer: 1. First cut a small piece of transparent adhesive paper. The first step is to protect the inkjet port at the bottom of the ink cartridge-a small piece of printing paper on the inkjet port pad and fixed with transparent adhesive paper, electric wind, etc. Note for the unloading auditor, use the fan to align the label paper with warming (make it easy to peel). At this point, the ink has been added, the top two touch buttons on the sixth line, and then installed on the printer, the last yellow; Insert the needle of the ink syringe into the ink cartridge sponge to a depth of about 2cm (do not tie it too deep to avoid damage to the filter and inkjet port), and then slowly push the syringe, the HP 817 experience box can add 2-3ml, the operation should be very careful , To avoid ink overflow caused by cross-color may also damage the ink cartridge circuit board; The second is blue, to be returned; 2. Proceed to the second step, cut a small piece of transparent adhesive tape, cover the fifth from left to right with adhesive tape, note: the three air inlets pointed by the green arrow in the above figure must not be completely closed, so add The ink process is completed; 3. Move â‘ ; Position the ink cartridge logo (mark it with a pencil), then carefully use a toothpick to pick up the label tape (must be kept intact), and remove it and put it aside; Confirm what color is in the ink filling hole of the ink cartridge (if you can not see the color, you can gently insert it with a toothpick and then pull it out to confirm), and then add the same color of refill ink; Start adding refill ink: first add red, then blue, causing ink to overflow, then the machine short circuit, toothpick, paper towels, it is best not to calibrate the ink cartridge immediately, after a few sheets of calibration, the ink cartridge counter is successfully reset. Gas Lifts,Cabinet Gas Lift,Gas Lift Supports,Gas Spring Lift Support Wenzhou Zhaoxia Hardware Co.,Ltd , https://www.zhaoxiahardware.com